Craft an exceptional modern system with the ENERMAXK8 PC case. Boasting a high-quality 0.7mm SPCC case body and tempered glass panels, the ENERMAXK8 combines durability with transparent visual design.
Experience outstanding expandability that supports up to an ATX motherboard, a 360mm AIO or a maximum of 7 fans. Equipped with USB 3.2 Gen1 Type A and Gen2 Type C, the ENERMAXK8 is tailored for mainstream needs. The fan bracket design and enlarged cable management space not only simplify system building but also contribute to the aesthetics of your refreshing system.
Embark on the journey of building your modern system now.
Support up to ATX motherboard installation.
You can change the screw into the included thumb screws to simplify the installation process without using a screwdriver.
Built-in two drive bays for flexible installation of HDD and SSD.
Feasible permutations as listed below
.3.5” HDD x 2
.3.5” HDD+2.5” SSD
.2.5” SSD x 2
ENERMAXK8 is competent in installing 360mm AIO at the front panel. You can simply pull out the built-in fan bracket and set the radiator on the inside of it while fans are on the outside to install a 360mm AIO with ease.
Pre-installed 3 ARGB PWM fans. Supporting up to 7 fans in the system build including 3 x 120mm fan installation at the front panel for better ventilation.
Switch the PCIe slots you need at any time to keep up with the latest graphic cards.
Support up to 390mm-width graphic card installation.
ENERMAXK8 is made with an SPCC 0.7mm high-quality case body to enhance the protection of the system. The extra enlarged cable management space and full-space cable holes accelerate the building of your streamlined PC system.
Effortlessly control the lighting effect with motherboard ARGB softwares & built-in 6-port control hub.
A mesh filter located at the top and a pull-out dust collector at the bottom can effectively minimize dust accumulation and facilitate effortless cleaning.
I/O panel built-in USB 3.2 Gen1 Type A and Gen2 Type C consistent with the latest Common EU Charger from the European Parliament.
① Power Button
② Headphone
③ Microphone
④ USB 3.2 Gen1 Type A
⑤ USB 3.2 Gen2 Type C
⑥ Reset Button (RGB Sync Button)
Die wiederverwendbaren Erweiterungssteckplätze können zum späteren Zeitpunkt je nach PC-Build wieder eingesetzt werden.
Eine mitgelieferte Grafikartenhalterung verhindert das Absenken der Grafikkarte und trägt zur Stabilisierung des PC-Builds bei.
Durch das magnetisch verschließbare und auch abnehmbare Seitenfenster kann der PC-Innenraum jederzeit einfach gereinigt und gewartet werden.
2x 2,5″/3,5″ SSD/HDDs sowie 2 weitere 2,5″ SSD/HDDs können hinter dem Mainboard-Tray installiert werden.